Teac MCDV600 - Manual (Page 35)

35
DIGITAL AUDIO SETUP (DIGITAL OUTPUT)
You can select the audio signal output suitable for the connected
device when playing the digital source.
OFF
Select this when you do not use the DIGITAL OUT or HDMI out
terminal.
No signal is output from these terminals.
ALL
Select this when the unit is connected to an audio component
equipped with a built-in digital audio decoder via the DIGITAL OUT
or the HDMI out terminal.
PCM only (Default)
Select this when the unit is connected to an audio component
such as amplifier/receiver, CD recorder or MD deck via the DIGITAL
OUT or the HDMI out terminal.
DOLBY DIGITAL SETUP (DUAL MONO)
You can select the channel output for the DVD discs recorded in
Dolby digital.
STEREO
Left channel is output from the left speaker, and right channel is
output from the right speaker.
L-MONO
Left channel is output from the front left and right speakers.
R-MONO
Right channel is output from the front left and right speakers.
Settings (AUDIO SETUP)
3D PROCESSING (Reverb mode)
This setting provides following sound effects by using just two
speakers:
OFF
CONCERT
LIVING ROOM
HALL
BATHROOM
CAVE
ARENA
CHURCH
AUDIO SYNC
This setting can cause delays in the sound signal in 10 ms increments
ranging from 0 ms to 200 ms (only for digital signals recorded on a
disc or stored in an USB device; unavailable for analog signals coming
from AUX 1 or 2).
Depending on the TV, it may take approximately 100 ms (0.1 sec.) for
an image to appear after video signals are input, causing the image
to appear after the sound coming from the MC-DV600 is heard.
If this happens or audio and video synchronization creates a less
than optimal viewing experience, adjust the delay with the left
(decrease) or right (increase) Cursor (g/t) buttons.