Toshiba TEC MA-1450-1 SERIES - Manual (Page 127)

6. PROGRAMMING OPERATIONS EO1-11095
6-22
ex.) To program PLU 90701 (7-up Small-B) again that
was once programmed and then deleted, by
copying the programmed data of PLU 90601 (Coke
Small-B):
Mode Lock: SET, enter 4, depress [@/FOR]
90701 [PLU] (PLU Code of the copy-destination)
[NS]
90601 [PLU] (PLU Code of the copy-source)
2 [ST] 307 [#] 213 [#] 705 [#] 700 [#] [#]
503 [#] 613 [#] 601 [#] 612 [#] 612 [#]
213 [#] 402 [#] [ST]
(Address 2, Name changed into: 7-up Small-B)
9 [ST] 7 [#]
(Address 9 , PLU Group No. changed into: 7 )
[AT/TL] (to end this submode)
6.9 PLU PROGRAMMED DATA COPYING
6.9 PLU PROGRAMMED DATA COPYING
This operation is used to copy the programmed data of a PLU item and to use it in programming another PLU
item, thus eliminating time in PLU programming operation.
CONDITION To program new PLUs or to change any programmed contents of PLUs:
Any time outside a sale (except the following case)
To change the PLU of the copy-destination with sales data not zero:
After PLU Reset
OPERATION Mode Lock: SET
4 [@/FOR] |PLU Code of the copy-destination| [PLU] [NS]
|PLU Code of the copy-source| [PLU]
The programmed data of the copy-source PLU is now copied to the copy-destination
PLU (except the PLU Code). Then follow the procedure on the page of Programming
or Changing to change data of any required Addresses.
TEC STORE
1343 PEACH DRIVE
PHONE : 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
12-19-1994 MON #3001
P04
090701
Coke Small-B
#00 090601
#02 7-up Small-B
#09 07
00030
0030