Toshiba TEC MA-1450-1 SERIES - Manual (Page 18)

6. OUTLINE OF PREPARATION PROCEDURE BEFORE OPERATING THE ECR EO1-11095
6-4
Installing the Journal Roll
1
6.1 INSTALLING THE RECEIPT/JOURNAL ROLL
Follow Steps 1 to 5 for “Installing the Receipt Roll” on the
preceding pages, except that the paper roll should be placed inner
side holder of the two holders.
2
There are the following two ways of a journal paper feed
procedure.
A: Manual installation
B: Installation using the [JF] key
A: Manual installation
1 Lift the green lever on the journal side.
2 Insert paper from the rear of the printer until the leading
edge of paper comes out by 30 cm.
3 Insert the leading edge of paper into the slit of the take-up
reel to take up paper two or three times.
4 Place the take-up reel on the take-up holder.
5 Lower the green lever.
6 Attach the receipt cover.
B: Installation using the [JF] key
1 Insert paper from the rear of the printer until it won’t go no
further.
2 Press the [JF] key to feed paper until the leading edge of
paper comes out by 30 cm.
3 Insert the leading edge of paper into the slit of the take-up
reel to take up paper two or three times.
4 Place the take-up reel on the take-up holder.
5 Attach the receipt cover.