Toshiba TEC MA-1450-1 SERIES - Manual (Page 14)

5. DISPLAY EO1-11095
5-2
5.1 NUMERIC DISPLAY
5.1 NUMERIC DISPLAY
AMOUNT (7 digits) Displays the numeric data, such as amount, quantity, etc.
When the amount is negative, the symbol “ - ” is displayed as well.
NOTE:
When the following codes are being entered, the digits for “RPT” and “DPT”
may be used as well (all 10 digits). On exceeding the 10 digits, the lowest 10
digits are being displayed.
Non-add Number (max. 18 digits)
Customer File No. (max. 12 digits)
DPT (2 digits) Displays the Department Code of the department item just entered. It stays lit when
repeating the same department item entry.
RPT (1 digit) Displays the repeat count of the same Department or PLU item. The count is indicated
from the second entry on, and only the lowest digit of the repeat count will be displayed
even when the count exceeds nine (such as “0” for 10, “1” for 11, etc.)
5.2 TRIANGULAR LAMPS
SIGN ON This lamp turns lit only when the Cashier Code Entry method is selected. It lights up when a
cashier has signed ON or signed IN. It goes out when the cashier has signed OFF or signed
OUT.
ALM Lights up with the alarm buzzer generated to indicate that the last operation or numeric entry was
an error. To clear the error status, depress the [C] key.
R OFF Lights up when the Receipt-OFF mode is declared by the [LOG/RECEIPT] (or [RECEIPT]) key.
In this condition, no receipts will be issued for a sale to be entered. It goes out by depressing the
[LOG/RECEIPT] (or [RECEIPT]) key again for Receipt-ON mode.
TL Lights up on a finalizing operation with the total amount displayed when the sale is finalized
without any amount tendered.
ST Lights up when the [ST] key is depressed, indicating that the displayed amount is subtotal. The
lamp is also illuminated when the [TXBL TL] or [FSTL TEND] key is depressed, indicating that
the displayed amount is the taxable total or food-stampable total. It also lights up when the
amount tendered is less than the sale total with the shortage amount (balance due) is displayed.
CG When an amount tendering operation is performed, it lights up with the change due displayed.
5.3 STATUS LAMPS
SLIP Lights up when a validation slip is properly inserted to allow validation print. It flickers to require a
validation when the validation compulsory status has been programmed on the last operation. It
also flickers to require an endorsement print using the Remote Slip Printer or the Receipt/Journal
Printer.
IN-LINE Flickers when a PC job is being executed.