Toshiba TEC MA-1450-1 SERIES User Manual
Page 17
6. OUTLINE OF PREPARATION PROCEDURE BEFORE OPERATING THE ECR
EO1-11095
6-3
4
Hold the paper roll so that the paper end will be fed from the
bottom.
6.1 INSTALLING THE RECEIPT/JOURNAL ROLL
5
Place the paper roll in the outer side holder of the two roll holders.
6
There are the following two ways of a receipt paper feed
procedure.
A: Manual installation
B: Installation using the [RF] key
A: Manual installation
1
Lift the green lever on the receipt side.
2
Insert paper from the rear of the printer until the leading
edge of paper comes out by 10 cm.
3
Lower the green lever.
4
Attach the receipt cover.
B: Installation using the [RF] key
1
Insert paper from the rear of the printer until it won’t go no
further.
2
Press the [RF] key to feed paper until the leading edge of
paper comes out by 10 cm.
3
Attach the receipt cover.