Telos Zephyr Xstream - Manual (Page 19)

USER’S MANUAL
Section 1: QUICK RESULTS 7
1.4 Basic Configuration
Your Zephyr should display a screen that looks like this:
Press the <CODEC> button once. You should see a screen that looks like this:
If it does not look like the above (i.e. some of the settings are different), your unit has been
previously configured. If it was, and you want to proceed with the Quick Start, you must erase
all of the previous settings. Before you go to the next step, check with the last person who used
this Zephyr Xstream to be certain that s/he no longer needs these settings.
To reset the Zephyr Xstream to the factory defaults:
• Press the <System> button (located beneath the LCD display) 5 times. You
will see a screen that looks like the following:
• Using the < 6> button move the dark bar so that “Restore Factory Defaults”
is highlighted (white text on a black background). Press the <SEL> Button.
You should see the following screen:
• Now press < 6> then press <SEL> to erase all settings to the factory
defaults.
We are now ready to configure your Zephyr Xstream. Follow these instructions exactly for the
most reliable path to success!
We will be using the <TEL> button. This will take you through the menus where the information
about your ISDN circuit is stored.
1. You have two options depending on what type of ISDN you are using: