Telos Zephyr Xstream - Manual (Page 262)

USER’S MANUAL
Section 12: System Functions and Remote Control 250
Description: Select analog/AESEBU input level in dB.
Name.......: zlog
Parameter..: [SYS|ISDN|IMON|SEXT|TIME|ITIM]
Group......: Zephyr-style
Description: Switch on a combination of logging channels. No parameter will switch off
logging.
Name.......: zloop
Parameter..: <off|far|near>
Group......: Zephyr-style
Description: Loop mode far, near or off, Default off
Name.......: znetwork
Parameter..: <ISDN|V35|Ethernet>
Group......: Zephyr-style
Description: Select network: ISDN, ethernet or V.35
Name.......: zreset
Parameter..: -
Group......: Zephyr-style
Description: Reset Zephyr (warm boot).
Name.......: zrxmode
Parameter..: <L3MO|L3ST|G722|L2|L2HALF|L2MO>
Group......: Zephyr-style
Description: Select receive mode L3-mono, L3-stereo, G.722, Layer2 stereo, Layer2 24kHz,
Layer2 mono, default: L3ST)
Name.......: zsetup
Parameter..: [<1..50>[<-|name <num1|-><num2|-><XmtMode><RcvMode><Rate>[<Compat>]]]
Group......: Zephyr-style
Description: Display or define setup.
Name.......: zspids
Parameter..: <line0..7> <number|->
Group......: Zephyr-style
Description: Set or delete SPID number.
Name.......: zstat
Parameter..: -
Group......: Zephyr-style
Description: Zephyr Remote Stat information ...
Name.......: ztelco
Parameter..: <NI1|PTP|ETS300>
Group......: Zephyr-style
Description: Select ISDN switch type.
Name.......: ztxmode
Parameter..: <L3DU|L3ST|L3JO|G722|L2MO|L2M128|L2DU|L2JO|L2HALF>
Group......: Zephyr-style
Description: Select transmit mode. Layer3: dual mono, stereo, joint stereo, G.722, Layer2:
mono, mono 128/112kbps, dual stereo, joint stereo, mono 24kHz. Default: L3DU)
Name.......: zver
Parameter..: -
Group......: Zephyr-style
Description: Display version information.
Name.......: ethermode
Parameter..: [<l3 or aac>]
Group......: Stream Decoder Description: Set the l3/aac streaming
Name.......: dcclient
Parameter..: [<host name or IP>] Group......: Stream Decoder Description: Set All Decoder
Clients