Telos Zephyr Xstream - Manual (Page 228)

USER’S MANUAL
Section 11: THE WORKS – Detailed Menu Reference 216
SPID Error ‐ The SPID entered for the indicated channel is incorrect. You may have
entered it wrong, or the Telco may have given you the wrong SPID (or entered the SPID
incorrectly in their switch).
Ready – This indicates that an ISDN line is present. It indicates that all handshaking with
the central office is complete and the line is ready to be used. Note: If Ready is displayed
and the Xstream cannot make or receive calls you may have the Telco option set
incorrectly or you may have omitted your SPIDs.
Conn: xxx ‐ The channel is connected to "xxx". "xxx" is the caller ID of the calling party if
available for calls originated from the far end, or the number dialed for calls originated
by the Zephyr Xstream.
A call timer below, the line status, displays the length of time the call has been
connected in the following format: Days‐hours:minutes:seconds
Pending Seize ‐ Outgoing call in progress; Request for call has been sent to the Telco
switch and Zephyr Xstream is awaiting acknowledgment.
Seized ‐ Outgoing call in progress; Telco switch has acknowledged the call request.
Proceeding ‐ Outgoing call in progress. Telco switch has acknowledged the call request
and is waiting for routing information from the network.
Outgoing Ring ‐ Outgoing call in progress; far end has generated a call alert signal.
Ring: xxx ‐ Incoming call from "xxx" has been detected and is being processed. "xxx" is
the caller ID of the calling party, if available.
Accepting Call ‐ Incoming call is being answered
Disconnecting ‐ Request to disconnect has been made. Awaiting acknowledgement.
Ended ‐ Request to disconnect has been made and the call has been cleared.
Inactive: The internal NT1 has not initialized. External NT1 (if any) is not active on the S
interface. Also displayed on ETS300 lines that have been "deactivated" or put to sleep.
Note this case is not unusual, and lines in this case will reawaken when used.
Note, this may also be displayed if the Telco setting in the TEL menu is set incorrectly.
i
ISDN TIP!
If you reboot the Xstream and the line status shows Ready & Ready, but you cannot make or
receive calls, check the following:
-Is the Telco selection in the TEL menu set correctly? Certain incorrect combinations may
cause a false Ready indication.
-If your ISDN protocol requires SPIDs, have you entered them in the TEL menu (See
below)?
-Is the Interface selection in the TEL menu set to ISDN? You won’t be able to place calls if
the ISDN interface is not selected.