Telos Zephyr Xstream - Manual (Page 99)

USER’S MANUAL
Section 5: GUIDED TOUR of the MENUS 87
Level In
This determines the nominal input level for the Xstream's analog inputs. As shipped from the
factory, Professional sets the system to a +4 dBu nominal input level. However, this can be
changed to 0dBu by changing internal jumpers. See Section 3 and Section 13 for information on
changing these jumpers.
Level Out
This determines the operating level at the Output (Receive from Network) jacks. Professional
sets the system to a +4 dBu nominal input level. Consumer sets the operating level to ‐11dBu
(nominal). Lower operating levels can be accommodated using an external pad.
Gain Trim
This allows a fine adjustment of send level. This adjustment allows compatibility with a variety
of equipment. This adjustment is in the digital domain and adjusts both the analog and
AES/EBU send level.
AUDIO - Screen 2
Pressing the AUDO Button a third time will show this screen with the following options.
Input Source
This allows selection of either the Analog, AES/EBU or Livewire input for your Send to Network
Audio.
AES Sample
This option determines what source is used to clock the AES/EBU output. The Input selection
clocks the AES/EBU output to the AES/EBU signal fed to the rear‐panel AES/EBU input and is the
most commonly used option. The Sync selection clocks the AES/EBU output to the AES/EBU
signal fed to the rear‐panel Sync‐in jack. See Section 11. (Detailed Menu Reference)
5.3.2 Zephyr Xstream's MX & MXP’s Audio Menu
Don't forget that you can create Location Setups to easily recall the menu selections of the
AUDIO menus. Even if the ISDN line is the same, these Location Setups can be used to program
these parameters (i.e. for different shows or uses in a dedicated situation. In the cases where
the ISND settings have not changed, just choose CANCEL when requested to reboot.