Assembly, Fender cut for wheel well tank – Tiger Products Co., Ltd JD 5065 / 5085 - 5105M User Manual
Page 44
Advertising
ASSEMBLY
Assembly Section 2-14
FENDER CUT FOR WHEEL WELL TANK
A notch will have to be cut into the left rear fender to allow room for the hydraulic tank filler
neck. The notch should start at 2 inches from the rear corner of the fender and create a 1 inch
deep arc that is 5 inches long. Trim lock should be used on the sharp edges..
(ASM-JD-0092)
Advertising