Tiger Products Co., Ltd JD 5065 / 5085 - 5105M - Manual (Page 50)

ASSEMBLY
Assembly Section 2-20
TRAVEL LOCK MOUNTING
Install the travel lock bracket with pin and clip on the draft beam. Slide the draft beam and
align the travel lock bracket hole with the mounting hole on the main frame. Install the capscrew,
lockwasher and hex nut as shown in the picture.
Raise the deck/flail to it’s upright position (Deck ear touches to stop bolt as shown in the
picture). Drill a 13/16” hole to the deck/flail ear through the draft beam as shown below. Insert the
supplied pin and clip through the hole.
(ASM-SIDE TRVL LOCK-0001)
STOP BOLT ADJUSTMENT
Extend the outboard cylinder all the way out. Adjust the stop adjustment bolt (located on the
top of the draft beam) out until it is up against the bonnet. Lock the bolt down with the ¾” hex
nut.
NOTE: When the outboard cylinder is fully extended, the bonnet or deck should either be up
against the stop or if travel locks are installed, it should be up against the travel lock. It may be
necessary to use either external or internal slugs on the cylinder to get the correct stroke. If the
cutter head is against the stop and the cylinder has stoke remaining, serious damage will occur.
Proceed to final preparation for operation instructions on the next page. ASM-SIDE MNTS-0003)