UNICOM Electric GST-2402 - Manual (Page 11)

as shown in Figure 2-3. The Switch will work with AC in the range 100-240V
AC, 50-60Hz.
Figure 2-3. The Rear Panel of SmartGST-2402
Desktop Installation
Set the Switch on a sufficiently large flat space with a power outlet nearby.
The surface where you put your Switch should be clean, smooth, level and
sturdy. Make sure there is enough clearance around the Switch to allow
attachment of cables, power cord and allow air circulation.
Attaching Rubber Feet
A. Make sure mounting surface on the bottom of the Switch is grease and
dust free.
B. Remove adhesive backing from your Rubber Feet.
C. Apply the rubber feet to each corner on the bottom of the Switch. These
footpads can protect the Switch from shock/vibration.
Figure 2 4 Attaching Rubber Feet to each corner on the bottom of the Switch