Set-up, Setting the retransfer film – Ultra electronic Prima 3 User Manual

Page 16

Advertising
background image

16

Set-up

(continued)

Setting the retransfer film

Do not touch the retransfer film

surface with your hands.

1.

Activate the slide knob and open the printer door.

When the slide knob is moved, the door opens
downwards. Hold the door with your hand and open it
slowly.

Do not put the ink ribbon or retransfer

film on the back of the door for mounting. Do not rest
your elbows or put any heavy object on the back of the
door as it may break.

2.

Remove the retransfer film cassette.

When you press the lever, a small portion of the
cassette pops out.

CAUTION

Press the cassette
removal lever.

3.

Insert the retransfer film into the cassette.

Stretch the retransfer film along three shafts with the
retransfer face of the film facing outside and insert the
bobbins into the bobbin holders firmly.
At this time, perform setting so that the film is inside the
guide. Wind the film to the wind spool more than three
stripes (two frames).
Otherwise the printer may fail.

Place the cassette upright on a flat surface during set-up.

When you need to take out the cassette, for instance, to
clean the printer, be sure to put it upright as shown in the
above illustration. When the film is put on the table with
its retransfer face down, dusts attach to the surface,
causing a failure of the printer.

Retransfer film cassette (yellowish
green)

CAUTION

CAUTION

Shaft

Bobbin holder (green)

Retransfer face
(do not touch the
surface)

Feed spool (green
bobbin)

Wind spool
(black bobbin)

Bobbin holder (black)

Wind the film by about
three stripes (two frames)
on the winding bobbin.

One frame

Guide

Black stripes

Advertising