Ultra electronic Prima 3 - Manual (Page 36)

36
Operation
(continued)
Coercivity setting mode
Set coercivity for writing data on the ISO compatible
magnetic stripe card.
> M G I S O T y p e
L o - C o
EXIT
ENTER
Exit user mode
Press to select the setting and press to save.
(The electronic beep sounds.The beep will not sound
if the buzzer mode setting is set to off.)
Lo-Co
238
×
10 2 [A/m] (300 [Oe])
Hi-Co
218
×
10 3 [A/m] (2750 [Oe])
Non-contact IC antenna setting mode
To use non-contact IC cards, set the antenna position
at which the cards stop.
> I C C o n t a c t P o s .
N o n e
EXIT
ENTER
Exit user mode
Set IC contact
position:
3 settings
Press to select the setting and press to save.
(The electronic beep sounds.The beep will not sound
if the buzzer mode setting is set to off.)
None
No contact
Ext. Unit
An IC unit contact is being used
Built-in
A built-in contact is being used
IC contact setting mode
When using IC cards, specify the contact position to
stop the cards.
Test print
Test print is provided for printing a test pattern
contained in the printer (there is only one pattern).
Operating the printer independent of the host computer
enables you to find out the source of trouble if there is a
problem in the system.
> I C A n t e n n a P o s .
N o n e
EXIT
ENTER
Exit user mode
Non-contact IC
antenna position:
3 settings
Press to select the setting and press to save.
(The electronic beep sounds.The beep will not sound
if the buzzer mode setting is set to off.)
None
No antenna
Ext. Unit
An IC unit antenna is being used
Added on
A compact IC unit is being used.
> T e s t P r i n t
O K ?
P r i n t i n g . .
ENTER
EXIT
Exit user mode
Press to carry out test printing.
(The electronic beep sounds.The beep will not
sound if the buzzer mode setting is set to off.)
A single-sided color pattern is printed. When test
printing is completed, the unit will automatically return to
ready status.
Unit No. Setting
Set Unit Number of the printers to be connected
> U n i t N o .
N o . 1
EXIT
Unit No:
7 settings
ENTER
P l e a s e ,
P o w e r O f f
After that press ,Then the message is displayed as shown below.
Exit user mode
Turn off the power
And then by turning on the power,
Unit No. setting mode is cancelled.
(The electronic beep sounds.The beep will not
sound if the buzzer mode setting is set to off.)
Press to select the setting and press to save.
EXIT
Card Thickness setting mode
The printer is designed to load only the 0.76mm or 0.25mm
thick cards. So set card thickness depending on the card
used.
> C a r d T h i c k n e s s
S t a n a r d
EXIT
ENTER
Exit user mode
Set the card thickness:
2 settings
[Standard and Thin]
Press to select the setting and press to save.
(The electronic beep sounds.The beep will not sound
if the buzzer mode setting is set to off.)
Standard: 0.76mm(0.03inches)-thick
Thin: 0.25mm(0.01inches)-thick
For changing card thickness, see “switching the card
thickness” on Page 21 of this manual