Ultra electronic Prima 3 - Manual (Page 26)

26
When the printer was occurred an
error during printing operation caused by above-
mentioned operation or others, the retransfer film was
rewinded about 3 panels. If the printer is turned off and on
the power or is initialized, the printer occur the printing an
error which is “INK RUNOUT” or print results problem
because of the printer try to print the used retransfer film.
Wind up the retransfer film about 3 panels by unused
panel. See p.18 “Caution when loading the retransfer film
cassette and/or the ink ribbon cassette” and p.26 “On
initialization when the retransfer film cassette and/or the
ink ribbon cassette is loaded”.
Turning off the power
1.
Check the printer status.
In ready, preheat or error status, check that printer
operations are suspended.
2.
Turn off the power.
Always wait 10 seconds or more before turning the
power back on again.
About the RESET button
When an error occurs in the printer, press the
RESET
button, then the
ENTER
button.
The printer is initialized with this operation.
If the error still persists, see p.46-47 and take the
appropriate actions.
Then, press the
RESET
button, and the
ENTER
button
again. The printer is initialized, and returns to the
“Ready” state.
(When you turn off the power, these procedures are not
necessary.)
CAUTION
On Initialization when the retransfer film
cassette and/or the ink ribbon cassette
is loaded
Dust or foreign particles may attach on the surface of
retransfer film and ink ribbon when their cassette are
removed from the printer.
This may cause defective printing such as image void,
defective retransfer etc.
To Avoid this, it is recommended that the retransfer film
and the ink ribbon are wound up one or two panels after
they are reloaded.
Please follow the initialization procedure described
below:
1.
Turn the power switch on, and wait until the LCD
panel displays “Preheat” or “Ready”.
2.
Depress the
RESET
key.
LCD panel displays:
3.
By depressing the key or the key, the
LCD panel change accordingly as shown below.
Select the wind-up condition, one or two panels.
(This set up is not memorized.)
•
Initialized after two panels of the retransfer film
and the ink ribbon are would up.
•
Initialized after one panels of the retransfer film
and the ink ribbon are would up.
•
Initialized without winding up. (Default)
4.
By depressing the ENTER key, the printer is
initialized according to the selected above set up
condition.
I n i t i a l i z e
O K ?
I n i t i a l i z e
2 ' n d P a n e l , O K ?
I n i t i a l i z e
N E X T P a n e l , O K ?
I n i t i a l i z e
O K ?
Operation
(continued)
Turn off the power switch when you won’t use the
printer for a prolonged period of time for power
saving.