Unitech PA962 - Manual (Page 10)

10
Unitech PA962
If a PCMCIA card is inserted into the PA962 without
previously attaching a Pulling Tag, the card can be
removed by affixing a length of adhesive tape to the
surface of the card and pulling the card out by pulling
outward on the piece of tape.
PCMCIA Pulling Tags
Pulling Tags simplify the removal of PCMCIA cards from the
PA962. Before inserting a PCMCIA card, remove one of the
three Pulling Tags from the Pulling Tag sheet and adhere it to
both sides of the PCMCIA card, leaving a short (approx. 89) tab.
To remove the PCMCIA card, simply pull outward on this tab.
Using the Stylus
CAUTION: Never use anything other than the PA9627s stylus on the
screen. Using another object as a stylus could cause permanent
damage.
To write data into a field on a form, use the stylus to print the letters
or numbers. Use very light pressure.
3.
To make a choice from a menu, lightly tap the tip of the stylus on
that choice.
2.
Hold the stylus as you would a pencil. 1.
Front side of PCMCIA card
Insert CF card to PA962
Find the CF drawer from PA962 package, insert CF card to the
CF drawer. Then insert the CF drawer to the PA962 and place
the CF slot door. Re-install the battery door to PA962 with screw
driver of PA962 stylus.
1.
3
2.
Your CF card.
CF drawer
! $& ' &)*+,$- ./012& 10)& 3 5 &&&&&&&&&&& www.pdffactory.com