VeriFone NURIT 8400 - Manual (Page 10)

S ETUP
Selecting Location
10 NURIT 8400 I NSTALLATION G UIDE
Environmental
Factors
• Do not use the unit where there is high heat, dust, humidity, moisture, or
caustic chemicals or oils.
• Do not use the NURIT 8400 in a known blasting area.
• Do not use the NURIT 8400 in an area of potential explosive atmosphere,
such as fuel or chemical storage or transfer facilities, or in any area where you
would be advised to turn off a vehicle’s engine.
• Keep the unit away from direct sunlight and anything that radiates heat, such
as a stove or a motor.
• Do not use the NURIT 8400 outdoors.
• Do not cover slots and openings of the device. They may be provided for
ventilation and protection against overheating. Never place the device near
radiators, or in a place where proper ventilation is not provided.
• Do not cover the terminal.
• Maintain at least 22 cm (8.5 in) of clear space around the terminal in its fixed
operating location, in order to assure good ventilation.
CAUTION
The NURIT 8400 is not waterproof or dustproof, and is intended for indoor use
only. Any damage to the unit from exposure to rain or dust can void any warranty.
CAUTION A keypad privacy shield is pre-installed on all models of the NURIT 8400. Failing
to install or removing the keypad privacy shield, or failing to instruct the
cardholder to obstruct visual observation of the PIN entry with his/her body and
hand, may render the terminal non-compliant with ISO 9564 for PIN protection
and may violate card association requirements for PIN entry devices.
If for any reason, the keypad privacy shield needs to be replaced, contact a
VeriFone service representative.
WARNING For persons using a pacemaker or other medical device, please read the
following important safety notes:
Though most electronic equipment and critical medical devices are shielded
against radio-frequency signals, it is important to realize the possibilities of
potential interference and to know the standard precautions that may be taken.
Consult the manufacturer of your medical device to determine its level of
shielding.