VeriFone NURIT 8400 - Manual (Page 21)

S ETUP
Connecting the Battery Pack
NURIT 8400 I NSTALLATION G UIDE 21
To disconnect the
battery pack
1 Disconnect the DC power supply cord from the terminal or power off the
terminal. See Powering On and Off the Terminal With a Battery Pack .
2 Remove the battery compartment cover. See Figure 4 .
3 Remove the connecting wires from the cable guide.
4 Remove the pin connector, connecting the terminal and the battery pack.
5 Remove the battery pack.
Figure 12 Disconnecting the Battery Pack
6 Close the battery compartment cover. See Figure 4 .
7 Connect the DC power supply to the terminal. See Figure 17 .
Battery Maintenance
• The supplied high-performance NiMH battery pack provides 7.2 V at
2000 mAh capacity.
• Before using the battery for the first time it is recommended to charge the
battery for 24 hours.
• When fully discharged, the battery pack fully recharges within eight hours
while installed in the terminal. When replacing a battery pack (or using a new
one), the capacity level is not relevant until the battery pack has completed an
initial eight hours of charging.
• The terminal can be connected to an AC/DC power supply indefinitely without
causing damage to the battery pack.
• In typical use, the life span of the battery pack exceeds 500 charge cycles,
after which, operating time decreases slowly.
• The battery pack has a self-discharge rate. It loses approximately 1% of its
charge per day when not in use. Replace the battery pack when the charge
capacity is too weak for normal operation.
CAUTION
Take care when installing the battery pack. If it is installed incorrectly, it may
explode. Use only a VeriFone supplied battery.