Vanguard Managed Solutions Vanguard 6500 PLUS - Manual (Page 34)

2-26 Installation
Installing Standalone Units
Retaining Screws Figure 2-6 shows the retaining screws on the processor card.
Figure 2-6. 6500 PLUS Processor Card with Retaining Screw
Procedure to Add a
Replacement Card Follow these steps to add a processor card to the standalone enclosure:
Front Spacer Panel
6500 PLUS
Processor Card
Backplane
Standalone Base
Retaining Screw
Step Action
1 Carefully insert the replacement card into the backplane's connector.
Be sure that the clear plastic insulator is in place, under the card.
When pressing the replacement card into the backplane connector,
use direct force. Wiggling the card may damage it.
The card's tabs and the backplane's connector are keyed, so you
cannot insert the card incorrectly.
2 From the old card, remove the spacer panel attached to the front
panel and mount it to the front panel of the new card (Figure 2-6).
3 Place the backplane and card into the bottom of the enclosure. Be
sure that the backplane and the card mounting hole are properly
aligned.
4 Secure the card to the enclosure using the retaining screw that held
the card to the bottom of the enclosure.