Vanguard Managed Solutions Vanguard 6500 PLUS - Manual (Page 84)

2-76 Installation
Setting Node to Default Configuration
Setting Node to Default Configuration
Introduction You can set a node to the default configuration in two ways:
• Set the DFLT switch on the front panel
• Select the Default Node selection from the CTP Main menu
Defaulting the
Node Follow these steps to default the node using the DFLT switch:
Step Action
1 Push the DFLT switch to the left and press the RESET button.
2 Push the DFLT switch to the right when the STATUS light turns
steady on and press the RESET button.
3 Push the DFLT switch back to the left when the STATUS light turns
steady on and press the RESET button.
When the STATUS light turns steady on, the node is set to default
values.
For more information about the Default Node menu option, see the
Vanguard ONS Basics Protocols Manual