Vivotek PZ7112 - Manual (Page 126)

VIVOTEK
126 - User's Manual
Electromagnetic Compatibility (EMC)
FCC Statement
This device compiles with FCC Rules Part 15� Operation is subject to the following two conditions�
■ This device may not cause harmful interference, and
■ This device must accept any interference received, including interference that may cause undesired
operation�
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules� These limits are designed to provide reasonable protection against harmful
interference in a residential installation� This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications� However, there is no guarantee that interference will not occur in a partial
installation� If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna�
■ Increase the separation between the equipment and receiver�
■ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected�
■ Consult the dealer or an experienced radio/TV technician for help�
Shielded interface cables must be used in order to comply with emission limits�
CE Mark Warning
This is a Class B product� In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures�
This device (PZ7112/PZ7122) complies with the essential requirements of the R&TTE Directive 1999/5/
EC� The following test methods have been applied in order to prove presumption of conformity with the
essential requirements of the R&TTE Directive 1999/5/EC�
This device (PZ7112/PZ7122) is a 2�4 GHz wideband transmission system (transceiver), intended for use
in all EU member states and EFTA countries, except in France and Italy where restrictive use applies�
In Italy the end-user should apply for a license at the national spectrum authorities in order to obtain
authorization to use the device for setting up outdoor radio links and/or for supplying public access to
telecommunications and/or network services�
This device (PZ7112/PZ7122) may not be used for setting up outdoor radio links in France and in some
areas the RF output power may be limited to 10 mW EIRP in the frequency range of 2454 – 2483�5 MHz�
For detailed information the end-user should contact the national spectrum authority in France�
Liability
VIVOTEK Inc� cannot be held responsible for any technical or typographical errors and reserves the right
to make changes to the product and manuals without prior notice� VIVOTEK Inc� makes no warranty
of any kind with regard to the material contained within this document, including, but not limited to, the
implied warranties of merchantability and fitness for any particular purpose�