Viper Model 480XV - Manual (Page 27)

28 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s , i n c .
disarming without a transmitter
This feature allows you to disarm the system without the trans-
mitter should it be lost, damaged, or disabled. In order to disarm
without a transmitter, you must have the vehicle’s ignition key,
know where the Valet switch is located, and have the PIN code.
Check with the installer for the location of the Valet switch.
Please refer to the Disarm/Valet Mode section of this guide for
instructions to enter the pin code.
Location of Valet switch____________________________________.
PIN code_________________________________________________.
The LCD remote will indicate disarm notification with 4 quick
beeps and 5 flashes of the and triggered zone icons.
entering your PIN
Entering your PIN code using the valet switch allows you to
disarm the system without using the transmitters. Your 4-digit
PIN code is noted on the back page of this manual. If you would
like to change this PIN for one that is easier for you to remember
please visit your installing dealer.
1. Turn the ignition key to the ON position.
2. Within 10 seconds, enter the first number in your PIN.
Press and release the Valet switch the same number of times
as the first digit in your PIN.
E Exxaam mp pllee:: If your PIN is 2345, press the Valet switch two
times.
➜
➜