VIPowER SmartDup VP-8220 - Manual (Page 17)

4. The LED display will show and beep a final countdown, then display the
maximum writing speed, for example:
5. The LED display will then show the test time and start the countdown process.
Flashing “00s” will be displayed until completed, indicated by a beep.
6. The copy process will automatically begin. Showing the writing time and count-
down process, flashing “00s” will be displayed again,
7. Upon completion, “00” is displayed, three beeps are heard, and the CD-R media
is ejected.
8. The Test & Copy routine can be repeated by inserting another CD title and/or
CD-R or CD-RW media.
9. If a failure occurs during the Self-Test, Test, Erase, or Copy modes, beeps are
heard, an “Er” is displayed and the CD-R media will be ejected.
(5) Test Only (H5/L5)
Sets the SmartDup to “Test Only” mode where it will test the integrity of both the data
and writable media. If you set SW4 to Low Speed, all operation steps will be the same
as High Speed, except the recording speed will drop to 4X only.
Test Only mode DIP switch settings: High Speed
Low Speed (4X)
1. Set the Power Switch to CD Duplicator ON position.
The LEDs will display the firmware version number, for example:
and then run through a series of test numbers:
00, 22, 33... 88, 99.
2. When the self-test is completed, a “rd” (ready) is displayed, followed by two
beeps, “00” and then the speed/function setting or
3. Insert your CD title into the top CD-ROM drive and blank CD-R or
CD-RW media in the bottom CD-RW writer. (If you put a CD-RW media
with data on it, The CD-RW will eject and show “Er.”)
4. The LED display will show and beep a final countdown, then display the
maximum writing speed, for example: