VIPowER SmartDup VP-8220 - Manual (Page 18)

16 SmartDup IDE CD Duplicator User’s Guide
5. The LED display will then show the minimum writing time remaining.
6. When the testing is complete, beeps are heard and CD-R media is ejected.
7. The Test Only routine can be repeated by inserting another CD title and/or
CD-R or CD-RW media.
8. If a failure occurs during the Self-Test, Test, Erase, or Copy modes, beeps are
heard, an “Er” is displayed and the CD-R media will be ejected.
(6) Copy Only (H6/L6)
Sets the SmartDup to “Copy Only” mode. If you set SW4 to Low Speed, all operation
steps will be the same as High Speed, except the recording speed will drop to 4X 0nly.
Copy Only mode DIP switch settings: High Speed
Low Speed (4X)
1. Set the Power Switch to CD Duplicator ON position.
The LEDs will display the firmware version number, for example:
and then run through a series of test numbers:
00, 22, 33... 88, 99.
2. When the self-test is completed, a “rd” (ready) is displayed, followed by two
beeps, “00” and then the speed/function setting or
3. Insert your CD title into the top CD-ROM drive and blank CD-R or
CD-RW media in the bottom CD-RW writer. (If you put a CD-RW media
with data on it, the CD-RW will eject and show “Er.”)
4. The LED display will show and beep a final countdown, then display the
maximum writing speed, for example:
5. The LED display will then show a flashing countdown, then continue to flash
during the writing process.
6. When the testing is complete, beeps are heard and CD-R media is ejected.
7. The Copy Only routine can be repeated by inserting another CD title and/or
CD-R or CD-RW media.
8. If a failure occurs during the Self-Test, Test, Erase, or Copy modes, beeps are
heard, an “Er” is displayed and the CD-R media will be ejected.