Vision Fitness ST200 - Manual (Page 10)

10
2
STEP
• Thread pull pins partially onto 2a (Qty. 1)
and 2c (Qty. 2).
• Lay the front center vertical (2f) on the
floor. Slide the seat support structure (2a)
over the open end of 2f. NOTE: You must
pull the pull pin out (2b) and hold it when
sliding over 2f. Release and engage the
pull pin in one of the lower holes of 2f.
• Slide the seatback support structure (2c)
over the open end of 2f. NOTE: You must
pull the pull pin (2d) out and hold, while
sliding over 2f. Release and engage the
pull pin in one of the upper holes of 2f.
• Attach the exercise card post (2e) to the
appropriate holes of 2f with two spring
(SW6.1x12.2x1.5T) and flat (6.4x14x1T)
washers, and two bolts (M6x1Px15L).
Tighten the bolts using a 4mm L-shaped
wrench.
• Place 2f on top of 1b. Slip a flat
(10.5x18x2T) washer over each bolt
(M10x1.5Px60L) and slide through the left
side. Attach a flat (10.5x18x2T) washer
and a nut (M10x1.5P) to each bolt on the
right side. Tighten using a 6mm L-shaped
wrench and a 17mm wrench.
BLUE BAG
2e
2f
1b
2a
2d
2c
2b