Vision Fitness ST200 - Manual (Page 15)

15
7
STEP
If assembling just the base unit (ST200),
proceed as follows. If assembling with the
leg press (ST250), refer to Step 5 of the
leg press assembly guide. Slide the small
steel end of cable #2 through pulleys F
and G. Remove the nuts from the slotted
bolt (M12). Slide the cable through the
slotted bolt (M12). Reattach the nuts to the
slotted bolt. With the threads pointing up,
turn the bolt clockwise into the lower end
of 6b with a 19mm wrench, until the
cable is taught. Finish by tightening the
upper locking nut to the surface of 6b and
the lower locking nut to the bolt head.
YELLOW BAG
F
G
Cable #2
6b