Vision Fitness ST200 - Manual (Page 17)

17
9
STEP
• Place the rear hole of the left decorative
cover (9a) over the threaded post on the
left side of structure 5e. Loosely attach a
spring (SW10.2x18.4x2.5T) washer and
a bolt (M10x1.5Px25L). Thread two bolts
(M10x1.5Px25L) and two spring
(SW10.2x18.4x2.5T) washers into the
two front holes. Tighten all bolts with a
6mm L-shaped wrench. Repeat on the
right side.
• Attach the front decorative cover (9c)
over the front surfaces of the side decorative
covers with four bolts and four spring
(SW10.2x18.4x2.5T) washers. Tighten
with a 6mm L-shaped wrench.
RED BAG
9a
9b
5e
9c