VOX Amplification USA VTX150 - Manual (Page 11)

11
POWER LEVEL control
PHONES jack
AUX IN jack
8. POWER LEVEL control
This adjusts the output wattage of the power amp.
When using only the VTX150 Neodymium itself:
0W–150W
When using an extension speaker: 0W–300W
NOTE: The power level setting is not saved in the
program.
9. AUX IN/PHONES section
AUX IN jack
Connect the analog output of an audio device to this jack. You
can connect a CD or MP3 player here, and then play along on the
guitar while listening to your favorite songs.
PHONES jack
Use this jack if you want to output directly to a mixer or record-
ing device, or when you want to use headphones. The signal that is output
from this jack is taken from directly before the power amp, and the cabinet
response of the guitar amp will be applied to it.
NOTE: If you plug a cable into this jack, sound will not be output from
the internal speaker or the extension speaker.
NOTE: Be sure to connect the headphones to this jack in stereo. If you
connect them in monaural, the sound will not be output through the
headphones.
Rear panel
1 2 5 3 6 4
1. POWER switch
This switch turns the power on or off.
2. AC power connector
This is where you connect the included power cord.