VOX Amplification USA VTX150 - Manual (Page 17)

17
HINT: When you’ve found a program that you like, and are interested in
knowing the actual settings, you can use this original value indication to
find out.
NOTE: The MASTER volume and POWER LEVEL controls are not pro-
grammable, so the original value indication is not available for these
controls. The original value indication will not appear when the tuner
function is turned on in Channel Select mode, nor when the unit is in
Manual mode.
Restoring the factory settings
Here’s how to restore all settings of the VTX150 Neodymium to their factory-
set state.
NOTE: This operation will erase all programs that had been saved to
channels, and will initialize the factory-set programs.
NOTE: This will also initialize the effect and noise reduction settings that
you made in Manual mode.
1. Turn off the power.
2. While holding down the CH1 and CH4 switches, turn on the power. When the
BANK and CHANNEL LEDs start blinking, release the two switches you had
been holding down.
HINT: If you decide to cancel initialization at this point, press the TUNER
(BYPASS) switch.
3. Press the TAP switch. The BANK and CHANNEL LEDs will change from
blinking to lit, and initialization will begin. In one or two seconds, initialization
will be completed, and the unit will enter Preset mode.
NOTE: Never turn off the power while initialization is in progress.