VOX Amplification USA VTX150 - Manual (Page 22)

22
Assigning the delay effect input level
1. Use the MOD/DELAY selector to select “TAPE ECHO,” “A.DELAY,” or
“CHORUS+DELAY,” and then use the DEPTH knob.
2. Press the pedal switch while the pedal LED is blinking.
Assigning the PITCH parameter of PITCH SHIFT
1. Use the MOD/DELAY selector to select “PITCH,” and then press the TAP
switch (alternatively, hold down the TAP switch and use the DEPTH knob).
2. Press the pedal switch while the pedal LED is blinking.
If you don’t want any function to be assigned to the
expression pedal
1. Press the TUNER (BYPASS) switch to select Bypass.
The VC-12SV’s pedal LED (the LED at the upper left of the expression pedal)
will blink for one or two seconds.
2. While the pedal LED is blinking, press the VC-12SV’s pedal switch. The pedal
LED will blink rapidly; the assignment of the expression pedal has been
cleared.
HINT: The assignment will also be cleared if you change the effect type
that’s assigned to the expression pedal.
However in the following cases, the assignment will not change; the
setting will be maintained.
- If the amp model’s GAIN parameter is assigned
- If the reverb effect’s input level is assigned
- If a parameter of a delay effect is assigned, and you switch between the
three types of delay effect
Minimum and maximum values for the expression
pedal
The minimum value is when the expression pedal is fully returned toward
yourself, and the maximum value is when the pedal is fully advanced away
from yourself.
When you assign a parameter to the expression pedal, the most appropriate
operating range for that effect, based on that parameter’s minimum value and
maximum value, will be assigned automatically as the minimum and maxi-
mum values for the expression pedal.