Adjusting the noise reduction – VOX Amplification USA VTX150 User Manual
Page 15
15
4.
Adjust the top panel knobs such as GAIN, VOLUME, TREBLE, MIDDLE, and
BASS.
5.
Turn the VALUE knob to set the noise reduction. This setting is also saved in
the program. For details, please refer to “Adjusting the noise reduction” (p. 15).
HINT:
Adjust the noise reduction so that there’s no unwanted noise when
you’re not playing your guitar.
6.
Press the TUNER (BYPASS) switch once again to defeat bypass (the TUNER
(BYPASS) LEDs will be dark).
7.
Set the effect.
If you plan not to use effects, set the VALUE, DEPTH, and REVERB knobs to
the “OFF” position. If the knobs have already been set to “OFF,” set them to
any position other than “OFF,” then set them back to “OFF.”
If you plan to use effects, select an effect, and adjust it as desired.
For example if you want to add delay, turn the MOD/DELAY selector to
“A.DELAY.” If the selector is already at “A.DELAY,” turn it to some other effect
type and then back to “A.DELAY.”
Use the TAP switch and DEPTH knob to set the delay time or delay level (the
amount of delay sound that is added).
DELAY LEVEL:
Turn the DEPTH knob (without holding down a
switch).
DELAY TIME:
Press the TAP switch twice (at the desired timing
interval).
DELAY FEEDBACK:
Turn the DEPTH knob while holding down the TAP
switch.
HINT:
For details on the effect types, please refer to “About the amp
models and effect types” (p. 25).
Adjusting the noise reduction
Here’s how to adjust the way that noise is suppressed.
NOTE:
Noise reduction is specified individually for each program. In
Preset mode or Channel Select mode, the noise reduction setting will be
lost if you switch to a different program or to Manual mode or turn off the
power before saving.
1.
Press the TUNER (BYPASS) switch to make the TUNER (BYPASS) LEDs light
(Effect Bypass On).
2.
Turn the VALUE knob to adjust the sensitivity of the noise reduction. Turning
the knob toward the right will produce stronger noise reduction. If the knob is
turned all the way to the left, noise reduction will be off and will have no effect.