VOX Amplification USA VTX150 - Manual (Page 14)

14
Channel Select mode (recalling user programs)
In Channel Select mode you can use the BANK switch and CHANNEL
switches to recall the programs that are saved in each channel of the bank; all
of the amp and effect parameters will switch automatically.
Switching to Channel Select mode
If the BANK and CHANNEL LEDs aren’t lit, you’re not in Channel Select
mode. Press the BANK switch or a CHANNEL switch; the BANK and CHAN-
NEL LEDs will light up, and you’ll be in Channel Select mode.
Switching channels
Press a CHANNEL switch to change channels. The program specified for that
channel will be selected, regardless of the position of the top panel selectors
and control knobs. If you press the BANK switch, the bank will change, and
the channel of the same number that had been selected in the previous bank
will be selected.
HINT: If an optional (separately sold) VOX VFX5 foot switch or VC-12SV
foot controller is connected to the rear panel, you can use your foot to
switch banks or channels. For details, please refer to “Using a foot switch
(VOX VFS5)” (p.19) and “Using a foot controller (VC-12SV)” (p.20).
Creating and saving sounds
You can create a sound either by starting with an existing program that’s close
to what you have in mind and then editing it, or by creating the sound “from
scratch” (i.e., from an initialized state).
Creating a sound
Here’s how to create a sound from scratch.
1. Enter Manual mode.
2. Use the TUNER (BYPASS) switch to bypass the effect (the TUNER (BYPASS)
LEDs will be lit up).
If you want to use an effect, you’ll add it last.
3. Use the AMP switch/selector to select the amp that you want to use.
HINT: For details on the amp models, please refer to “Amp models” (p. 25).