Verizon 7500 - Manual (Page 156)

030-300536 Rev. A 156 August 2007
User Guide VersaLink Wireless Gateway (Model 7500)
16.16 Routing
In the Advanced screen, click Routing. The Routing table maintains the routes or paths of where specific types of
data will be routed across a network.
To add a new static route in the Router, click New Route.
Routing
IP Interfaces The list of active interfaces on the Router and their IP and Subnet mask address.
eth0 is the local LAN interface.
lo0 is the loopback interface.
mainPPP is the WAN interface
Destination The IP address or subnet of the Route.
Gateway Indicates were to send the packet if it matches this route.
Netmask
If the Route is a Network route, Subnet Mask is used to specify the subnet address.
If the Route is a Host route, then the Host Route check box should be selected.
Metric The RIP metric to be assigned to this route if and when it is advertised using RIP.
RIP Indicates whether a static route should be advertised via RIP.
Type Indicates the type of route: Network route or Host route.