Verizon 7500 - Manual (Page 94)

030-300536 Rev. A 94 August 2007
User Guide VersaLink Wireless Gateway (Model 7500)
Uplink Settings for Ethernet WAN Uplink (Routed IP protocol)
Tunneling Factory Default = Enable
If Enabled, this option allows PPP traffic to be bridged to the WAN. This feature
allows you to use a PPPoE shim on the host computer to connect to the Internet
Service Provider, by bypassing the Router’s capability to do this.
DHCP Client Selecting a option allows you to either Enable or Disable the DHCP Client.
Click the top option labeled (enable DHCP Client) to allow the Router to obtain an IP
address automatically from your service provider.
Click the bottom option labeled (disable DHCP Client) to allow the Router to accept
static IP address information. Then, manually enter the IP values into the fields. Obtain
these values from Verizon.
IP Address The IP network address that your Router is on.
Subnet The IP subnet address that your Router is on.
Gateway The Router’s IP gateway address.
DNS Primary Provided by Verizon.
DNS Secondary Provided by Verizon.
Note: The values for the IP Address, Gateway, DNS Primary, and DNS Secondary are all “Override of the value
obtained from the PPP connection,” They default to “0.0.0.0,” in which case the override is ignored. It is
recommended that you do not change the values unless Verizon instructs you to do so.