Verizon 7500 - Manual (Page 161)

030-300536 Rev. A 161 August 2007
User Guide VersaLink Wireless Gateway (Model 7500)
If the settings you have entered in the Private LAN Configuration screen are incorrect, the following warning
messages may be displayed in pop-up screens. If this occurs, check the settings in the Private LAN Configuration
screen.
Warning Message Check Private LAN DHCP Settings
Start Address is not part of the Subnet Check the value in the DHCP Start Address field
End Address is not part of the Subnet Check the value in the DHCP End Address field
End Address is below the Start Address Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds Check the values in the DHCP Lease Time fields
Seconds must be between 0 and 59 Check the Seconds value in the DHCP Lease Time field
Minutes must be between 0 and 59 Check the Minutes value in the DHCP Lease Time field
Hours must be between 0 and 23 Check the Hours value in the DHCP Lease Time field
16.19 Public LAN—Multiple IP Address Passthrough
In the Advanced screen, click Private LAN. The following screen will appear. The Public LAN feature allows
VersaLink to use LAN IP addresses that are accessible from the WAN. Public LAN allows your computer to have
global address ability.
NOTE: To utilize the Public LAN feature in your VersaLink, Verizon must support Public LAN and Static IP. If
you have questions about the feature, contact Verizon for details.
If you change the settings in this screen, click Apply. If you click Reset, the screen will refresh and the previously
saved settings will remain active.
IMPORTANT: Whenever you change the Private LAN settings, the screen will display the changes; however, you
must click Apply to allow the changes to take effect in the Router. (Private LAN is the default setting for VersaLink.)
To enable Public LAN, click the Public LAN DHCP Server Enable box (a check mark will appear in the box).