Western Telematic WTI NetReach APS-16M User Manual

Page 31

Advertising
background image

5-15

Confi guration

7. Supervisor Mode: Permits or denies access to Supervisor Mode at this

port. When enabled (Permit), and a password that permits Supervisor

Mode is entered, the port will allow access to Supervisor Mode

commands. When disabled (Deny), the port will

not enter Supervisor

Mode, even when a password that normally permits access to Supervisor

Mode is entered. (Default = Permit).
Note:

The Supervisor Mode cannot be disabled at Ports 1 or 2.

8. Logoff Character: Defines the Logoff Character for this port. The

Logoff Character determines the command(s) or character(s) that must

be issued at this port in order to disconnect from a second port (Resident

Disconnect). (Default =

^X ([Ctrl] plus [X])).

Note:

When redefining the Logoff Character, make certain to select a

character that does not normally occur in your data.

9. Sequence Disconnect: Enables/Disables and configures the Resident

Disconnect command. This prompt offers the option to either disable the

Sequence Disconnect, or select a one character format or a three character

format. (Default = One Character). Note the following:
• When a Resident Connection is initiated, the APS-8/16M will send a

message which lists the connected ports, and displays the one character

or three character command that will be required in order to disconnect.

• The One Character Disconnect sequence is intended for situations

where the destination port will not receive the disconnect command.

When the Three Character format is selected, the disconnect sequence

will pass through to the destination port prior to breaking the

connection.

• When the One Character format is selected, resident connections are

terminated by entering the selected Logoff Character only. There is no

need to press [Enter] before and after the Logoff Character when the

One Character format is selected.

• When the Three Character format is selected, the Resident Disconnect

Sequence will use the format "[Enter]

LLL[Enter]", where L is the

selected Logoff Character.

Advertising