Western Telematic WTI NetReach APS-16M User Manual

Page 48

Advertising
background image

8-2

APS-8M / APS-16M Asynchronous Port Switches; User’s Guide

To connect ports, proceed as follows:
1. Access command mode as described in Section 5.1. If the Password

Prompt is displayed, enter a password that permits Supervisor Mode.

2. Invoke the /C command to connect the desired ports.

a) Resident Connect: To connect your resident port to another port,

type

/C xx [Enter]. Where xx is the number or name of the port

you want to connect. The APS-8/16M will display the numbers of

the connected ports, along with the command sequence that will be

required in order to disconnect the two ports.

Example: To connect your resident port to Port 8, type

/C 8 [Enter].

b) Third Party Connect: (Supervisor Mode Only) To connect any

two ports (other than your resident port), type

/C xx XX [Enter].

Where

xx and XX are two port names or numbers. The APS-8/16M

will display the numbers of the two connected ports.

Example: To connect Port 5 to Port 6, access command mode using

a password and port that permit Supervisor Mode, and then invoke

the following command:

/C 5 6 [Enter].

When the /C command specifies the port name, it is only necessary to enter

enough letters to differentiate the desired port from other ports. Type an

asterisk (

*) to represent the remaining characters in the port name. For

example, to connect your resident port to a port named "SALES", the connect

command can be invoked as

/C S*, providing no other port names begin with

the letter "S".

8.1.1.2. Disconnecting Ports
There are three different methods for disconnecting ports, the Resident

Disconnect, the Third Party Disconnect, and the No Activity Timeout.

Providing the Timeout feature is enabled, a No Activity Timeout will

disconnect resident ports or third party ports.

Note:

When Any-to-Any Mode, Buffer Mode, or Passive Mode are

selected, Option 64 in the Port Parameters Menu determines how the

DTR signal will react when the port disconnects. The DTR signal can

either be held low, held high, or pulsed and then held high.

Advertising