Western Telematic WTI NetReach APS-16M - Manual (Page 68)

11-8
APS-8M / APS-16M Asynchronous Port Switches; User’s Guide
/P Set RS232 Port Parameters
Displays a menu which allows the user to select options and parameters for
the selected port. Section 5.5.3 describes the procedure for defining port
parameters.
Availability: Supervisor Mode Only
Format:
/P [x] [Enter]
Where x is the number or name of the port to be configured. If the
port number or name is not specified, the APS-8/16M will display the
configuration menu for your resident port.
Response: The Port Parameters Menu is displayed.
/S Display Port Status
Displays the Port Status Screen, which lists current conditions and parameters
for all ports. When the Supervisor Mode is active, the /S command will
display the current status of all APS-8/16M Ports. If the Supervisor Mode is
not active, then the /S command will only display status information for the
ports that are specifically allowed by the password entered at log in. For more
information on the Port Status Screen, please refer to Section 7.1.
Availability: Supervisor Mode / Non-Supervisor Mode
Format:
/S [Enter]
Response: Displays Port Status Screen
/SD Display Port Diagnostics
Provides more detailed information regarding the operational status of each
port. If your password and port permit Supervisor Mode, the /SD command
will display status information for all APS-8/16M ports. However, if your
password or port do not permit Supervisor Mode, then the /SD command
will only display information for the ports specifically allowed by your
password. For More information on the Port Diagnostics Screen, please refer
to Section 7.2.
Availability: Supervisor Mode / Non-Supervisor Mode
Format:
/SD [Enter]
Response: Displays Port Diagnostics Screen