Western Telematic WTI NetReach APS-16M - Manual (Page 32)

5-16
APS-8M / APS-16M Asynchronous Port Switches; User’s Guide
10. Timeout Disconnect: Enables and selects the Timeout Period for this
port. If enabled, and the port does not receive or transmit data for the
specified Timeout Period, the port will disconnect. In Any-to-Any Mode,
Passive Mode, or Buffer Mode, the default setting for this item is "OFF".
When the port is set for Modem Mode, the default setting for this item is
15 minutes.
Notes:
• The Timeout Disconnect is also applied to non-connected ports that
are left in command mode. If no additional data activity is detected,
an unconnected port will exit from command mode when the
Timeout Disconnect value expires.
• When connected ports time out and are disconnected, both ports will
also exit from command mode.
11. Response Type: Selects the type of messages that this port will send in
response to commands. The user can select Verbose (English Text), Terse
(Numeric / Abbreviation), or Quiet Mode (No Response).
(Default = Verbose).
12. Command Echo: Enables or Disables the command echo for this port.
(Default = On).
13. Accept Break: Determines whether the port will accept breaks received
from the attached device, and pass them along to a connected port. When
enabled, breaks received at this port will be passed to any port that this
port is connected to, and sent along to the device connected to the other
port. When disabled, breaks will be refused at this port, and hence, not
sent to the other port. (Default = Yes)
14. Invalid Access Lockout: Enables/Disables the Invalid Access Lockout
feature as described in Section 5.5.4. Briefly, the Invalid Access Lockout
feature can be used to automatically disable a port when a user-defined
number of invalid access attempts are detected. (Default = Off.)