Wolf Appliance Company 811504 - Manual (Page 12)

Pro Wall Hood Installation 12
Low-Profile Wall Hoods
WALL PREPARATION
Minimum 2" (51) x 4" (102) lumber is required to construct
wall framing. Refer to the illustration below for mounting
hole locations and a cross-section view of a typical instal-
lation.
HOOD PREPARATION
To remove filters, press upward then rotate bottom
outward. Refer to the illustration below. To aide in removal,
remove center filter first. Gloves should be worn when
handling filters.
FILTER
SIDE VIEW
SPRING GREASE
CUP
Filter removal.
WIDTH OF HOOD
26 1/4 " (667) TO
FRAMING STUD CENTERS
13 1/8 "
(333)
HOOD CENTERLINE
8 1/4 "
(210) TO
CENTER
OF STUD
FRAMING
STUDS
Wall framing.
Framing must be able to support the weight of the hood
and internal blower, if applicable.