Wolf Appliance Company 811504 - Manual (Page 16)

Pro Wall Hood Installation 16
Before making electrical connections, make sure the
electrical power is turned off at the service panel.
1) Remove the electrical box cover from inside the hood.
Insert Romex ® from service panel (and Romex ® from
in-line or remote blower, if applicable) through the back
of the hood and into the electrical box. Secure with an
appropriate electrical connector. Refer to the illustra-
tion below.
2) Use wire connectors provided to connect black to
black, white to white and green to green/bare wire. For
in-line and remote blowers, attach the cord assembly
to Romex ® from the blower.
3) Place all wiring connections inside the electrical box
and reinstall electrical box cover. Verify all wires are
secure and not pinched between cover.
4) Insert cord assembly plug into hood receptacle. Refer
to the illustration below. Turn on power and check
operation.
ELECTRICAL BOX
(INSIDE HOOD)
Location of electrical box. Location of receptacle.
RECEPTACLE
(INSIDE HOOD)
Electrical Connection
IMPORTANT NOTE: Refer to specific installation instruc-
tions provided with each blower assembly for additional
mounting and wiring instructions.