Weider 831.159530 - Manual (Page 14)

14
30. Wrap the Press Cable (80) around a “V”-Pulley
(38). Attach the Pulley and a Long Cable Trap
(50) to the indicated hole in the Press Seat
Frame (12), using a 3/8” x 4 1/4” Bolt (104), a
3/8” Washer (75) and a 3/8” Nylon Locknut (74).
Be sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley.
30
29. Slide a 3/8” x 5” Bolt (61) through a 3 1/2” Pulley
(37), a Cable Trap (44), and the Leg Press Arm
(22) from the indicated side. Be sure the Cable
Trap is oriented as shown.
Wrap the Press Cable (80) around another 3 1/2”
Pulley (37). Attach the Pulley and a Cable Trap
(44) to the 3/8” x 5” Bolt (61) with a 3/8” Nylon
Locknut (74). Be sure the Cable Trap is turned
to hold the Cable in the groove of the Pulley.
Do not tighten the Nylon Locknut yet.
29
44
44
61
22
74
80
74
104
38
75
22
44
12
50
80
80
37
31. Wrap the Press Cable (80) around the indicated
3 1/2” Pulley (37) on the Leg Press Arm (22).
Make sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley. Tighten the
3/8” Nylon Locknut (not shown) used in step 29.
32. Wrap the Press Cable (80) around a 3 1/2” Pulley
(37). Attach the Pulley and a Cable Trap (44) to
the Support Brace (7) with a 3/8” x 3 3/4” Bolt
(62), a 3/8” Washer (75), and a 3/8” Nylon
Locknut (74). Make sure the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
31
32
37
37
75
74
7
80
44
62
37