Weider 831.159530 - Manual (Page 9)

9
12
13
14
55
55
66
66
9
Adjustment knob
must be on this side
64
10
54
64
12
59
71
72 3
64
64 66
55
6
10
66
66
64
11. Press a 2” Square Inner Cap (59) into the Press
Top Frame (13).
Attach the Press Top Frame (13) to the Press
Upright (6) with two 5/16” x 2 3/4” Bolts (55), a
Long Support Plate (34), and two 5/16” Nylon
Locknuts (64).
Attach the back hole on the side of the Press Top
Frame (13) to the Top Frame (5) with a 5/16” x 2
3/4” Bolt (55), the Pulley Support Plate (107), and
a 5/16” Nylon Locknut (64).
Attach the next hole on the side of the Press Top
Frame (13), a 3 1/2” Pulley (37) and a Cable Trap
(44) to the Top Frame (5) with a 3/8” x 4” Bolt
(91), the Pulley Support Plate (107), and a 3/8”
Nylon Locknut (74). Do not overtighten the
Nylon Locknut; the Pulley must be able to turn
easily.
Do not tighten the Nylon Locknuts (64, 74) yet.
11
107
34
13
5
55
91
55
6
64
64
44
37
74
54
1
9
64
64
59
12. Attach a Bumper (71) to the Press Seat Frame
(12) with a Bumper Screw (72).
Attach the Press Seat Frame (12) to the 5/16” x
2 1/2” Carriage Bolts (54) in the Press Base (3)
with two 5/16” Nylon Locknuts (64).
Attach the Press Seat Frame (12) to the Press
Upright (6) with two 5/16” x 2 3/4” Bolts (55), two
5/16” Washers (66), and two 5/16” Nylon
Locknuts (64).
Do not tighten the 5/16” Nylon Locknuts (64)
yet.
13. Attach the Butterfly Seat Frame (10) to the
Butterfly Front Leg (9) with two 5/16” x 2 3/4”
Bolts (55), two 5/16” Washers (66), and two 5/16”
Nylon Locknuts (64). Do not tighten the Nylon
Locknuts yet. Be sure the Adjustment Knob
(not shown) is on the indicated side.
14. Attach a Bumper (71) to the Butterfly Front Leg
(9) with a Bumper Screw (72).
Attach the Butterfly Front Leg (9) to the 5/16” x
2 1/2” Carriage Bolts (54) in the Butterfly Base (1)
with two 5/16” Nylon Locknuts (64).
Attach the Butterfly Seat Frame (10) to the
Butterfly Upright (4) with two 5/16” x 2 3/4” Bolts
(55), two 5/16” Washers (66), and two 5/16”
Nylon Locknuts (64).
Tighten all of the Nylon Locknuts (64, 74)
used in steps 1 to 14.
71
72