Weider 831.159530 - Manual (Page 20)

20
53. Locate and open the parts bag labeled “SEAT
ASSEMBLY.”
Press a 1 1/2” Square Inner Cap (100) into the
bottom of a Seat Bracket (11). Press two 1” x 2”
Inner Caps (70) into the ends of the Seat Bracket.
Insert a 1/4” x 1 3/4” Carriage Bolt (93) into the
center hole of a Support Plate (57). Attach the
Support Plate to a Seat (25) with two 1/4” x 3/4”
Screws (90). Attach the Seat to the Seat Bracket
(11) with the Carriage Bolt, a 1/4” Washer (84),
and a 1/4” Nylon Locknut (106). Attach the other
end the Seat to the Seat Bracket with 1/4” x
1 3/4” Screw (98) and a 1/4” Washer (84).
Loosen the Adjustment Knob (not shown) by turn-
ing it counterclockwise, and pull it out as far as
possible. Insert the Seat Bracket (11) into the
Butterfly Seat Frame (10) and align an adjustment
hole with the Adjustment Knob. Snap the Knob into
the adjustment hole and turn it clockwise until tight.
53
93
57
70
90
11
84
106
100
70
84
98
10
25
54. Attach the Butterfly Backrest (53) to the Butterfly
Upright (4) with two 1/4” x 2 3/4” Screws (94) and
two 1/4” Washers (84).
54
53 4
84
84
55. Press a 1 1/2” Square Inner Cap (100) into the
bottom of a Seat Bracket (11). Press two 1” x 2”
Inner Caps (70) into the ends of the Seat Bracket.
Insert a 1/4” x 1 3/4” Carriage Bolt (93) into the
center hole of a Support Plate (57). Attach the
Support Plate to a Seat (25) with two 1/4” x 3/4”
Screws (90). Attach the Seat to the Seat Bracket
(11) with the Carriage Bolt, a 1/4” Washer (84),
and a 1/4” Nylon Locknut (106). Attach the other
end the Seat to the Seat Bracket with 1/4” x
1 3/4” Screw (98) and a 1/4” Washer (84).
Loosen the Adjustment Knob (51) by turning it
counterclockwise, and pull it out as far as possi-
ble. Insert the Seat Bracket (11) into the Press
Seat Frame (12) and align an adjustment hole
with the Adjustment Knob. Snap the Knob into the
adjustment hole and turn it clockwise until tight.
55
94
94
Seat Assembly
93
57
70
90
11
84
106
100
70
84
98
51
12
25