Weider 831.159530 - Manual (Page 23)

ADJUSTING THE SEAT
To adjust the height of the Seat (25) on the Press
Seat Frame (12), loosen the Adjustment Knob (51) by
turning it counterclockwise, and pull it out as far as
possible. Move the Seat to the desired height and
snap the Knob into an adjustment hole in the Seat
Bracket (11). Turn the Adjustment Knob clockwise
until tight.
The Seat (not shown) in the Butterfly Seat Frame (not
shown) can be adjusted in the same way.
The weight system is designed to be used with your own weight set (not included). The steps below explain how the
weight system can be adjusted. Refer to the accompanying exercise guide to see the correct form for several exer-
cise.
Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immediate-
ly. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
23
ADJUSTING THE PRESS PLATE
To adjust the position of the Press Plate (24), pull out
the Press Pin (46) and slide the Adjustment Tube (23)
to the desired position in the bracket on the Leg
Press Arm (22). Line up one of the adjustment holes
in the Adjustment Tube with the hole in the bracket
and re-insert the Press Pin.
Bracket
23
46
24
22
6
ADJUSTING THE PRESS BACKREST
To adjust the Press Backrest (20) loosen the
Adjustment Knob (51) by turning it counterclockwise,
and pull it out as far as possible. Move the Backrest
to the desired position and snap the Knob into an
adjustment hole in the Backrest Bracket (not shown).
Turn the Adjustment Knob clockwise until tight.
51
12
51
25
11
ADJUSTMENTS
20