Weider 831.159530 - Manual (Page 17)

17
41
37
74
49
49
83
Rod
Ball
Large tabs
must be on
this side
4
75
75
41. Identify the Ab Cable (83); it is approximately
220.25” long and it has a ball on one end and a
loop on the other.
Wrap the Ab Cable (83) around a 3 1/2” Pulley
(37). Place two Pulley Covers (49) over the
Pulley; make sure that the large tabs are in the
position shown. Attach the Pulley and Pulley
Covers to the Butterfly Upright (4) with a 3/8” x 4”
Bolt (91), two 3/8” Washers (75), and a 3/8” Nylon
Locknut (74). Be sure that the Cable is between
the Pulley and the rod on the Upright, and that
the ball is on the side shown.
42. Remove the two 3 1/2” Pulleys (37) from the
Double U-bracket (42). Wrap the Ab Cable (83)
around a Pulley. Reattach the Pulley to the
Double U-bracket with the 3/8” x 2” Bolt (79) and
3/8” Nylon Locknut (74).
43
79
37
44
83
43
74
43. Wrap the Ab Cable (83) around the other 3 1/2”
Pulley (37) removed in step 38. Reattach the
Pulley and Cable Trap (44) to the bottom set of
holes in the Pulley Plates (43) with the 3/8” x 2”
Bolt (79) and the 3/8” Nylon Locknut (74). Be
sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley.
44
83
88
1
37
103
44. Wrap the Ab Cable (83) around a 3 1/2” Pulley
(37). Attach the Pulley and a Cable Trap (44) to
the Butterfly Base (1) with a 3/8” x 1 3/4” Bolt
(103) and a 3/8” Nylon Jamnut (88). Make sure
the Cable Trap is oriented as shown.
42
74
79 42
83
37
91
44