Weider PRO 408 - Manual (Page 7)

7
5. Press a 50 x 50mm Square Cap (20) into each end of
the Top Frame (8).
Place the Top Frame (8) on top of the Uprights and
slide the mounting brackets (B) down into the
Uprights. Secure the Top Frame with two M10 x
68mm Bolts (31), four M10 Washers (38) and two
M10 Nylon Locknuts (37).
Tighten the Nylon Locknuts used in steps 1–5
now.
5
3. Slide the mounting bracket (A) on the Bench Frame
(1) onto the Carriage Bolts (30) in the Base and
secure it with two M10 Nylon Locknuts (37). Do not
tighten the Nylon Locknuts yet.
Fasten the mounting bracket on the Frame (1) to the
Right and Left Base (5, 4) with two M10 x 72mm
Bolts (27) and two M10 Nylon Locknuts (37). Do not
tighten the Nylon Locknuts yet.
3
27
37
37
1
37
30
30
5
4
A
20
38
31
37
38
B
38
B
31
38
8
20
4. Slide the Left Upright (6) over the Bolts (30) in the
Left Base (4) and secure it with two M10 Nylon
Locknuts (37).
Do not tighten the Nylon Locknuts yet.
Mount the Right Upright (7) in the same way.
Caution: Make sure both Uprights are oriented
correctly. To do this, look at the upper four holes
for the Weight Rests. On one side the four holes
are spaced evenly, and on the other there is a
greater distance between the two lower of the
four holes. The side with the even spacing must
be facing the seat of the bench on both Uprights
(see inset drawing).
4
30
30
37
4
37
37
7
6
37
Holes for
Weight Rests
The Four
Upper
Holes Are
Evenly
Spaced