Weider PRO 408 - Manual (Page 8)

8
9. Press a 2” Round Cap (25) into the weight tube (B).
Press a 50 x 50mm Square Cap (20) into each end of
the Leg Lever (3).
Attach the Bumper (24) to the Front Leg (2) with an
M4 x 19mm Screw (34).
9
25
20
20
3
B 20 34
24
2
7. Insert four 25 x 25mm Square Caps (22) into the
ends of the Backrest Tubes (11).
Attach the Backrest (13) to the Backrest Tubes (11)
with four M6 x 38mm Screws (35) and four M6
Washers (39).
Make sure the Backrest Tubes are oriented as
shown.
Do not tighten the Screws yet.
7
8. Lubricate an M10 x 175mm Bolt (29). Attach the
Backrest Tubes (11) to the Bench Frame (1) with the
Bolt and an M10 Nylon Locknut (37).
Do not overtighten the Nylon Locknut; the
Backrest must be able to move freely.
Tighten the four Screws (35) from the previous
step.
Lower the Backrest (13) onto the Adjustment Tube
(12).
8
6. Insert a Weight Rest (9) into one of the holes on each
Upright (6, 7).
Press a 1 1/2” Round Cap (21) into each end of the
Adjustment Tube (12). To mount the Adjustment
Tube, slide the end without the locking clip (A)
through the Right Upright (7) from the inside. Then
slide the end with the locking clip into the Left Upright
(6) and rotate the locking clip into place.
When moving the Adjustment Tube (12), always
make sure the locking clip has snapped into place
around the Left Upright.
6
9
A
21
21
7
6
12
13
11
35
39
22
39
35
29
Lubricate
37
13
1
11
12
22