Weider 16.8ST - Manual (Page 15)

15
28. Wrap the High Cable (73) around a 4Ó Pulley (35).
Attach the Pulley and a Cable Trap (44) to the top
hole in the Pulley Bracket (91) attached to the Leg
Press Cable (76), with a 3/8Ó x 1 3/4Ó Bolt (60) and a
3/8Ó Nylon Jam Nut (63).
29. Feed the bolt on the High Cable (73) up through the
next slot in the Top Frame (1).
Wrap the High Cable (73) around a 4Ó Pulley (35) in
the direction shown and attach the Pulley to the Top
Frame (1) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat
Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42),
and a 3/8Ó Nylon Jam Nut (63).
28
29
44
63
73
73
1
35 63
55
55
54
42
35
30. Feed the bolt on the High Cable (73) down through
the next slot in the Top Frame (1).
Wrap the High Cable (73) around a 4Ó Pulley (35) in
the direction shown. Attach the Pulley to the Top
Frame (1) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat
Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42),
and a 3/8Ó Nylon Jam Nut (63).
30
42
35
54
55
55
63
73
1
31. IMPORTANT: Follow both Cables (73, 76 [not
shown]) from end to end; make sure that they are
in the grooves of the pulleys, and that the Cables
and pulleys move smoothly.
Thread the 1/2Ó Plain Nut (68) part way onto the bolt
at the end of the High Cable (73).
Place the 1 1/2Ó Flat Washer (40) on top of the
Weight Tube (36). Tighten the bolt at the end of the
High Cable (73) into the threaded hole in the Weight
Tube until the Cables (73, 76 [not shown]) are tight.
Tighten the 1/2Ó Plain Nut (68) against the 1 1/2Ó Flat
Washer (40).
31
Bolt
36
26
40
68
73
60
76
91