Weider 16.8ST User Manual
Page 20
20
49. Make sure that all parts have been properly tight-
ened. The use of the remaining parts will be
explained in ADJUSTMENT, beginning on page 22 of
this manual.
Before using the training system, pull each cable a
few times to make sure that the cables move smooth-
ly over the pulleys. If one of the cables does not
move smoothly, find and correct the problem.
45. Attach the upper end of the Shroud (56) to the two
ÒLÓ-brackets on the Top Frame (1) with two 1/4Ó x 3/4Ó
Bolts (17), two 1/4Ó Flat Washers (71), and two 1/4Ó
Nylon Locknuts (25). Make sure that the indicated
corner of the Shroud is lined up with the indicated
corner of the Top Frame. The Bolts must be
inserted through the square holes in the Shroud.
Do not tighten the Bolts yet.
45
71
ÒLÓ-Brackets
1
25
17
56
46. Attach the lower end of the Shroud (56) to the bracket
on the Stabilizer (5) with four #8 x 3/4Ó Screws (32).
The Screws must be inserted through the square
holes in the Shroud and into the Tinnerman Clips (38).
Tighten the bolts used in step 45.
47. Insert a 1Ó Round Inner Cap (103) into each end of
the Lat Bar (61).
46
47
32
32
56
103
103
61
32
38
38
5
Bracket
Align
Corners
17
71
48. Attach the Curl Pad (21) to the Curl Post (83) with
four 1/4Ó x 3/4Ó Bolts (17).
83
17
21
48
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. If
there is any slack in the cables, you will need to remove the slack by tightening the cables. See TROU-
BLE-SHOOTING AND MAINTENANCE on page 24.